BR Systems Electric Lift Cover

BR Systems

$805.00

Colour
Handlebar Orientation

Made from durable Kodra 600 Denier polyester fabric with a PVC backing, this cover is designed to fully enclose two bikes on a BR Systems Electric Lift rack.


Made from durable Kodra 600 Denier polyester fabric with a PVC backing, this cover is designed to fully enclose two bikes on a G2 Sport rack.


OCD Covers have a universal handlebar pocket that will accommodate an 800mm wide straight mountain-bike or the curved handlebar set of the cruiser bike range. Some vehicle and rack mountings require the handlebar of the inner mounted bike to be rotated 90' to lie parallel to the back of the vehicle to avoid contact with the vehicle while traveling. We accommodate this with a custom pocket for turned handlebars. If you require this design then please choose the Turned Handlebar version when ordering. A small extra fee is charged as each of these covers is individually cut and made.


Ideal for wheel sizes of 26"- 29", five adjustable straps around the sides allow you to tension the cover as required for a snug fit. It is advised that the cover is not applied too tightly however to minimise the risk of abrasion from the vibrations of travel. To protect the cover we supply a pedal pouch which you will find velcroed to the inside of the cover at the base where the zips meet. It is put on the outer pedal where it touches the cover.

Each cover is supplied with a sturdy storage bag.

Standard colours offered are sage and silver or grey and silver.  We also offer red as an optional colour, but advise that the red pigment is not as UV stable as the other colours and fading can be expected over time. All combinations of these colours are available, but some are offered only as a custom option. Please choose your colour preference when ordering. 


Cover Fitting

Before starting,  fit the pedal covers which you will find velcroed to the inside of the cover tongue, over the outside pedals on each side of the rack, making sure that the pedal is located above the crank shaft.  To fit the cover, lower the rack platform and place the cover over the top of the bikes, locating the handlebars in the pouches and the tongue of the cover between the van attachment bars at the back. . Raise the rack platform for easy access to the underside of the cover and close the zips around the bike wheel arches. Bring the tongue through from the bottom at the back to clip into place on the front of the cover Adjust all straps to give a tidy fit. Do not over-tighten the adjusting straps as if they are very tight the risk of abrasion to the inside of the cover during travel is increased.


SKU: 139476 TAG: Van Mount
 

This product has been added to your cart

CHECKOUT