EziGrip E-Rack Cover



Set Options

The OCD EziGrip cover is manufactured from 600 denier Polyester Oxford with a PCV laminated inner layer for extra strength and waterproofing.

The cover is designed to take two bikes with 29" wheels or 27.5" wheels fitted with fat tyres. Handlebar pockets allow for a closer fitting design to avoid flapping and road noise. The five straps around the sides of the cover can be adjusted to tighten the cover further, which is especially useful if you only have one bike or are carrying bikes of different sizes.  It is recommended that the straps are not over-tightened as tension over the pedal and deraillier areas may cause rubbing and abrasion to the inside of  cover. Pedal covers are supplied to further protect the inside of the cover from abrasion during travel.

Cover Fitting

Fit the cover by opening the zips on either side around the wheel arches and undoing the tensioning straps.  Remove the pedal covers from their position on the inside of  the covers at the centre bottom and place them securely over the pedals on that will sit against the cover. Place  the cover over the top of the bikes, locating the handlebars in the pockets.  Open the velcroed splits at the bottom of the front of the cover and fit these over the lights,then close the velcro around the light brackets.  After fitting the centre bottom of the cover around the number-plate support, tilt the rack forward and close the zips from the back at each end, fitting the leather reinforced recess around the bottom bar of the carrier. Finish by closing the flap on the far side of the centre bottom and then tilt the rack up again. Adjust the tensioning straps, taking care not to over-tighten and you are ready to travel.

We have timed the fitting process at approximately 3 minutes even for an inexperienced user.

SKU: 139476-106

This product has been added to your cart